MAIN FEATURES

Simerics–MP+ for Turbo^® , one of the vertical applications of  Simerics-MP+, provides accurate virtual testing for the analysis and performance prediction of turbomachinery, including Axial/Mixed flow/Centrifugal Compressors, Pumps, Motors, Turbines, and connected systems for whole spectrum of specific speed and full operating range including shutoff. For liquid systems, Simerics–MP+ for Turbo’s proprietary cavitation Module accurately models vapor, free gas and liquid compressibility to enable the analysis of performance, pressure ripple, and cavitation damage.

• Comprehensive physics

  Flow, Turbulence, conjugate heat transfer, real gases, aeration, cavitation, particles.

• Accurate predictions

  Excellent correlation with test data over the full operating range.

• Fast model creation, even faster simulation speed

  Less than an hour from CAD to simulation, < 15 min. for steady-state results.

• Able to model complex details down to the micro scale

  Accurately model leakage gaps, tip clearances, balance holes, etc.

KEY ADVANTAGES

Simerics-MP+ for Turbo^® is built on Simerics^® MP+’s baseline technology to provide a transient 3-D simulation software uniquely suited for the analysis and design of single or multistage turbo pumps, turbines, and compressors.

• 

  Accurate Results:

  Simerics-MP+ for Turbo consistently provides simulation predictions that are within 5% of physical hardware test results over the full operating range. (Testimonial)

• 

  Superior Cavitation/Aeration Module:

  Simerics-MP+ for Turbo rigorously and independently accounts for the formation, transport, and effects of non-condensable gases (e.g. air) and cavitation vapor, as opposed to using a lumped effective compressibility approach. (Testimonial)

• 

  Fast Calculation Times:

  Simerics-MP+ for Turbo has repeatedly been shown to be more than 5 times faster than other commercial codes, enabling more complex simulations, including full transient analysis when needed. (Testimonial)

• 

  Robust Solver:

  Simerics-MP+ for Turbo is able to converge extremely difficult problems, even those with detailed micro-scale features and/or severe cavitation.
  (Testimonial)

• 

  Ease of Use:

  Less than 30 minutes is typically required to create a model with the aid of templates, automated mesh generation and a single GUI for set-up, simulation, and post-processing.
  (Testimonial)

• 

  Virtually Unlimited Support:

  Simerics-MP+ for Turbo comes with extensive training and virtually unlimited support in helping set-up cases. (Testimonial)

TEMPLATES

FOR AXIAL-CENTRIFUGAL COMPRESSORS, PUMPS, TURBINES, AND MOTORS

Simerics-MP+ for Turbo^® provides templates specifically to enable the rapid set-up and simulation of a full range of turbomachinery.

Turbomachinery Templates: